Talking about the processing capacity of the river pebble sand making machine

The river pebble sand making machine requires the particles of the sand making material to be fine. What is the processing capacity of the river pebble sand making machine?

When the crushing cavity of the pebble sand making machine enters the non-fine crushed stone, the rear thrust plate acts as a reliable part of the pebble sand making machine to protect the important parts of the pebble sand making machine from damage. The rear thrust plate is cast as a whole from cast iron, and a slot or several small holes are opened in it to reduce the strength of its section; or it is cast into two pieces and then connected with screws to form a combined thrust plate.

However, when the stone that cannot be finely sanded enters the fine crushing cavity, the equipment will be overloaded and transmitted to the thrust plate, causing the thrust plate to break or the screws of the combined thrust plate to be cut off. And the machine will complete the work and play a reassuring role.

The river pebble sand making machine requires fine particles of sand making materials.

In general, needle-like material enters the fine crusher compartment. While the requirements for crushed stone are very strict on the type and grade of their particles. The reason is that cubic sand has a locking effect between particles due to its edges and corners, and the continuous gradation of sand can reduce voids. At the same time, cubic sand occupies a larger surface area than round sand, allowing asphalt to stick to material or cement to material, reducing the possibility of displacement. This design principle is not only very applicable. But also easy to control, low cost to replace the assured parts, simple to operate. And also conducive to maintenance and protection of the entire equipment from damage.

The processing capacity of the pebble sand making machine directly affects the wear of the blow bar.

With the increase of processing capacity, the particle size of the product becomes coarser, the crushing rate decreases. And the unit loss rate of the blower also increases; changing the size of the discharge gap can also change the thickness of the product particle size to a certain extent. So the wear of the blower is also affected. certain influence. Second, the material to be crushed also has multiple effects on the wear of the blower. Including: material hardness, feed particle size and water content, etc.. The material hardness has a greater impact, corresponding to different crushed materials, different river pebble sand making machines should be used .

Another factor is the effect of speed.

The size of the line speed directly affects the impact energy and crushing rate exerted by the blow bar on the material. And plays a decisive role in the particle size of the product. How to solve the phenomenon that the parts of the pebble sand making machine are easy to wear. The easily damaged parts of the pebble sand making machine mainly include plate hammer, rebound lining, casing lining, rotor lining and so on. However, the wear and failure time of the plate hammer is relatively short, and the repair cost is quite high. Therefore, the first solution to wear and tear is to reduce the loss of the plate hammer.