Reason for corrosion protection on the appearance of sand making machine

Corrosion will occur when the sand machine is used for a long time or does not pay attention to the environment. Especially in the case of open-air operation, we should do a good job of appearance anticorrosion. The corrosion of the parts of the sand making machine will directly affect its work efficiency and service life. So the anti-corrosion work is very important for the equipment of the sand making machine, just spray the spray gun on the equipment. In fact, the coating of the sand machine is strictly required. There are many parts in the machine. If major parts need to be sprayed, other parts need to be protected with newspaper or tape. Small parts that cannot be reached by the airbrush should be sprayed manually.

Reason for corrosion protection on the appearance of sand making machine

(1) The vibration of sand making machine equipment is large during operation, and it should be installed on the concrete foundation. To reduce vibration, noise and impact on nearby buildings and structural foundations, hardwood is placed between the sand making equipment and the concrete foundation. Gaskets, rubber belts or other damping materials.

(2) The basic drainage channel of the equipment should be laid with metal plates. And the tilt Angle should be large enough (according to the fluidity of the material is not less than 50). So as not to hinder the smooth discharge of broken products.

(3) The outlet size of sand making equipment should be adjusted according to the required product size. When adjusting, loosen the T-bolt and tension spring. Open the adjustment seat with the top bolt, insert or remove the spacer of the appropriate thickness, and retracted the lifting bolt. Adjust the seat under the jaw weight of the portable grinding device, attach it to the bracket lug, and press the washer. Adjust the preload of the spring to ensure that the thrust plate is in close contact with the thrust pad when the sand maker is running. But as long as there is no tapping, the pre-pressure will not be too much, the seat will lock.

As a result, raw materials and carefully sprayed equipment greatly extend their service life and increase revenue.

Every user should pay attention to the anti-corrosion work of the sand making machine equipment. The above is the specific operation method of the anti-corrosion coating appearance. I hope it will be helpful to the users who are using the sand making machine equipment.