The solution of jaw crusher in the working problem of vibrating screen

Jaw crusher is the first process of mine crushing, and its vibrating screen is an important screening equipment in my country’s industrial production, which is widely used in mineral processing, building materials, chemical and other industries. There are many types of vibrating screens. Commonly used vibrating screens mainly include circular vibrating screens, linear vibrating screens, high-frequency screens and so on. Jaw crushers often encounter some problems during the use of vibrating screens.

For the production process of the industry that uses a lot of mechanical equipment, it is necessary to do daily maintenance work on the jaw crusher and other equipment, and solve the failure of the jaw crusher equipment accessories. When the vibrating screen of the jaw crusher is working, the screening quality will be poor. It may be due to the blockage of the screen holes of the jaw crusher screen, the increase of the fragments entering the screen, the increase of the moisture of the material entering the screen, the uneven feeding, the thick material layer, and the screen is not pulled tightly. At this time, it is necessary to reduce the load of the vibrating screen, change the inclination angle of the screen frame, adjust the feeding, reduce the feeding, and tighten the screen.

When the vibrating screen is working normally, its speed is too slow, because the transmission belt is loose, and the transmission belt should be tightened. The heat of the vibrating screen bearing is because the bearing lacks lubricating oil, the bearing is blocked, and the bearing is worn. The operator of the jaw crusher in the industry needs to inject lubricating oil into the bearing, clean the bearing, check and replace the sealing ring, and replace the bearing.